Temperature Sensor

Dimensions
  • W: 1,25 cm
  • H: 3,85 cm
  • D: 0,6 cm
Technical specification

Built-in Sensors

Temperature

Operating Temperature °C

-55°C - +125°C

Operating Temperature °F

-67°F - +257°F

Operating Humidity % RH

5% - 90% RH, Non condensing

Altitude

<3000m

Safety features

Over Voltage, Short Circuit, Reverse polarity

Wiring

The temperature sensor has three main pins: Power +, Power –, and Output. 

The Power + pin is connected to the controller's 5V output, depending on the sensor's voltage requirement. 

The Power – pin is connected to the controller's GND (ground) to complete the power circuit. 

The Output pin is wired to one of the controller’s analog input pins for reading temperature data. 

Adding a new Temperature Sensor
  1. Choose Controller
    1. Tap on the Controller that you would like to add new I/O to.
    2. To edit the I/O, click on the Controller to which the I/O is added.
  1. Configurable I/O - list
    1. Tap on the Configurable I/O tab.
       
  1. Add button - Configurable I/Os
    1. Tap on the Add button.
  1. Choose type - Configurable I/O list
    You should choose the type of the I/O from the list that you would like to add.
  1. New Temperature sensor - DS18B20
    Fill the following form:
    1. Name - Write the name of the Temperature sensor.
    2. Roles - Select the Role from the list.
    3. Pin -  Choose Pin. It is physical place on the Controller where I/O is connected to it.
    4. Identifier - Enter the identifier of the I/O in the electrical project in this field.
    5. Address - Tap on +/-.

For more details follow next steps.

To confirm your choice tap Submit and Save.

  1. Select Roles
    1. You can select desired Role or Roles - multiple choice if you tap on the checkboxes next to them.
    2. Tap on Save/Done.
  1. Choose Pin
    1. Tap on the radio button next to the Pin that you would like to choose.
    2. To confirm selection tap on Save/Done.